Cleaning And Storage; Troubleshooting - EASYmaxx BY1207-F Bedienungsanleitung

Convector Heater
The control lamp on the On / Off
switch lights up when the device is
heating.
L
The thermostat must be switched
on.
5. Activate the fan to heat up the room
faster. To do this, flick its On / Off
switch so that the control lamp on it
lights up.
6. Once the room gets to the level of heat
you want, slowly turn the thermostat
dial anticlockwise until you hear a click.
The thermostat will then regulate the
temperature. As part of this, the control
lamps may turn off and on again.
7. To switch off the device, turn the ther­
mostat dial anticlockwise to the MIN
position and flip the On / Off switches
for the heating elements and the fan
to the Off position. The control lamps
go out.
8. Pull the mains plug out of the plug
socket and allow the device to cool
down completely.
CLEANING AND
STORAGE
Please Note!
■ Do not use alcohol or other caustic or
abrasive cleaners or rough sponges to
clean the device. These may damage
the surfaces.
• Before you clean the device, make
sure that the device has been discon­
nected from the mains power and has
cooled down.
• Keep the device clean and dust it
regularly.
• Wipe off any dirt with a damp cloth.
Then dry with a soft cloth. The device
must be completely dry before it is
used.
06746_Inlay_de-en-fr-nl_A5_V1.indb 15 06746_Inlay_de-en-fr-nl_A5_V1.indb 15
• Store the device in a clean, dry place
which is protected from dust and is out
of the reach of children and animals
when it is not in use.

TROUBLESHOOTING

If the device does not work properly,
check whether you are able to rectify the
problem yourself. If the problem cannot
be solved with the steps that are listed,
contact the customer service department.
Do not attempt to repair an elec-
trical device yourself!
The device does not work.
The device is not switched on.
► The device only works when the
thermostat is switched on. Turn the
thermostat dial a little further clock­
wise.
► Flip the On / Off switch for at least one
heating element. The control lamp on
the On / Off switch must light up.
The mains plug is not inserted in the plug
socket correctly.
► Correct the fit of the mains plug.
The plug socket is defective.
► Try another plug socket.
There is no mains voltage.
► Check the fuse in the electrical dis­
tributor (fuse box).
The overheating protection has been
triggered.
► Switch off the device, pull the mains
plug out of the plug socket and allow
the device to cool down completely.
Then try again. If the device still does
not work or still switches off, contact
the customer service department.
EN
15
01.08.2022 13:24:16 01.08.2022 13:24:16