EASYmaxx BY1207-F Bedienungsanleitung Seite 13

Convector Heater
■ The device must not be set up directly beneath a wall socket.
■ Do not use this heater in the immediate vicinity of a bath, a
shower or a swimming pool.
■ Do not use this heater if it has previously been dropped.
■ Do not use this heater if it has visible signs of damage.
■ Use this heater on a horizontal and stable surface.
■ The protective grille does not offer sufficient protection for
small children and frail people.
■ Do not make any modifications to the device. If the device or
the connecting cable are damaged, they must be replaced or
repaired by the manufacturer, customer service department or
a similarly qualified person (e.g. specialist workshop) in order
to avoid any hazards.
■ The device must always be disconnected from the mains power
when left unattended, when not in use and before cleaning it.
DANGER –
Danger of Electric Shock
■ Use and store the device only in
closed rooms.
■ Do not use the device in rooms with
high humidity.
■ No liquid must be allowed to enter the
device. Never immerse in water and
ensure that it cannot fall into water or
become wet.
■ If the device does fall into water, pull
the mains plug out of the plug socket
immediately. Only after this should
you retrieve the device from the water.
Never attempt to pull it out of the wa­
ter while it is connected to the mains
power!
■ Never touch the device and the con­
necting cable with wet hands when
the device is connected to the mains
power.
■ Do not use the device if it has mal­
functioned or fallen into water. Have
it checked in a specialist workshop
before using it again.
06746_Inlay_de-en-fr-nl_A5_V1.indb 13 06746_Inlay_de-en-fr-nl_A5_V1.indb 13
WARNING – Danger of Injury
■ Keep the packaging material away
from children and animals. There is a
danger of suffocation.
■ Supervise children to ensure that they
do not burn themselves on the device.
■ Lay the connecting cable in such a
way that it does not present a trip
hazard.
WARNING – Danger of Fire
■ Only use the device if the feet have
been properly mounted. Never place it
directly on the floor or other surfaces!
The heat could cause material dam­
age or a fire.
■ Do not insert anything into the open­
ings of the device and make sure that
they are always clear. Otherwise it
could overheat and be damaged.
■ Do not connect the device along with
other consumers (with a high wattage)
to a multiple socket in order to prevent
overloading and a possible short
circuit (fire).
EN
13
01.08.2022 13:24:16 01.08.2022 13:24:16