VINCENT SA-T7 MK Bedienungsanleitung Seite 36

CONNECTIONS FOR THE STANDBY CONTROL
power control connection between the amplifier and these further devices through the outputs of the two
devices which are connected directly. For that reason, every HiFi component that accepts power control
signals is also equipped with a power control output. Thus, in theory it is possible to provide an infinite
number of HiFi components with the power control signal. This approach, to loop a signal through a
chain of components, is commonly referred to as "daisy chaining".
SA-T7MK
Many devices which can be controlled by a switching signal (not preamplifiers or integrated
amplifiers), have two terminals which do not differentiate between input and output. In this
case either of the two can be selected.
"POWER CONTROL" sockets of preamplifiers or integrated amplifiers must not be inter-
connected! All receiving devices must not be connected to more than one preamplifier or
integrated amplifier (directly or indirectly)!
Check that the electricity supply to your home is appropriate to the device. The required voltage and
frequency can be read on the back of the device beside the socket for the mains. If the electricity supply
is appropriate, push the inlet connector of the supplied mains cable firmly into socket for the mains on the
back of the device. Connect the other end of the mains cable to a mains socket.
This device is equipped with a switch (18) that can be used to change the country-specific voltage from
230 V to 110 V.
Please never actuate the switch during operation! The voltage must only be switched by
a technician, since the device fuse must also be replaced after actuation of the switch!
Information about the device fuse can be found on the back of the device.
Unauthorised actuation of the switch will void any warranty claim!
36
(POWER CONTROL)
power control cable
CONNECTION OF THE POWER CABLE
SWITCHING THE VOLTAGE
main amplifier
e.g. SP-T700
second main amplifier
e.g. second SP-T700