Yuasa YCX6 Bedienungsanleitung Seite 7

Selecting the correct charging rate
To select the correct charging rate (A) consult the Ah rating displayed on the label of the
battery.
Find this Ah rating in the table below and use the AMP button on the charger to select the
suggested A rating. Where two A ratings are available, the higher option will result in a faster
charge time.
Charge rate 1A
Charging
3-20Ah
Up to
Maintenance
100Ah
Selecting power supply mode
Power supply mode is designed for recovery of overdischarged batteries which would be too
low for the smart charger function to recognise. We do not recommend using power supply
mode for any other application.
Do not use as a stand-alone power supply for other 12V devices.
•
Do not use as a vehicle memory maintainer (risk of damage to pyrotechnic components
•
and vehicle damage).
Press and hold the MODE button for three seconds to select power supply mode.
When selected, press and hold the MODE button for three seconds again to turn off power
supply mode.
After selecting power supply mode, do not allow reverse polarity connection to battery
terminals as it will cause permanent damage to the charger.
ON
PS
YCX6
4A 6A
12-80Ah 18-120Ah
Up to Up to
120Ah 180Ah
Power supply mode selected
YCX12
2A 8A
2-60Ah 24-160Ah
Up to Up to
120Ah 240Ah
12A
36-240Ah
Up to
360Ah
7