Modster XGT Betriebsanleitung Seite 16

Manual - XGT
16
5. Use the steering trim dial to adjust the neutral position of the
servo. Push the dial counter-clockwise to trim left, clockwise to
trim right, until your vehicle tracks straight when steering at neu-
tral position.
6. lf the direction of travel on the rudder is opposite, slide the
steering reverse switch to the other position. WARNING: Do NOT
slide the throttle reverse switch unless you completely unders-
tand this function and it is necessary to switch. Otherwise seri-
ous damage may occur.
7. Adjust the servo angle by turning the switch up or down.
Turn the switch to upper position for arger servo angle. Turn the
switch to lower position for smaller servo angle.
8. After you finished,turn off ESC power, then unplug battery and
put in a dry safe place to cool down before you use it again.
3. To slowly drive forward, pull the throttle
trigger slightly. Adjust the speed by pulling
the trigger. Push the trigger to brake/reverse.
Release the trigger to keep your vehicle still.
4. Rotate the wheel counter-clockwise to turn
left. Rotate the wheel clockwise to turn right.
www.modster.at