Mounting And Connection - Sophos APX 320 Schnellstartanleitung

2. Mounting and Connection

For instructions on how to mount your access point, please see the Operating Instructions
under www.sophos.com/get-started-ap.
Connect the LAN (PoE) port of the access point to a PoE switch or PoE injector using an
RJ45 Ethernet cable.
Sophos Firewall or
Router
Sophos Firewall or
Router
The access point will now boot and try to receive an IP address via DHCP (either from the
Sophos firewall/UTM or another DHCP server in your network).
After successfully receiving an IP address, the access point attempts to communicate
with either the Sophos firewall/UTM or Sophos Central. In order to do so, the firewall needs
to either be the default gateway of the access points or be on the default route (most likely
your route to the internet).
Whilst waiting for DHCP and searching for the wireless controller, the access point status
LED will show its current state (please see the following table).
Quick Start Guide APX 320/530/740
PoE Switch
Switch PoE Injector
ENGLISH
Access Point
Access Point
4