Jog Mode / Add Station - Julius Mayer JM35-F Serie Montageanleitung

Jog mode Enable/Disable
1. Power is ON (motor is connected and ready for operation).
2. 1x Press P2 programming key. Motor beeps.
3. Press UP key 1x. Motor beeps.
4. Press P2 programming key 1x. Motor beeps 3 x*.
OK! Jog mode enabled/disabled.
Add handheld and wall transmitters
1. Power is ON (motor is connected and ready for operation).
2. First select the desired channel by pressing the K1 (or K2) key
(selected channel is shown in the display) you want to duplicate (not applicable for JMHS-1).
3. Also select the channel to be programmed on the new handheld transmitter (not applicable for JMHS-1).
4. Press the P2 programming button (back) 2 times on the already programmed hand-held or wall transmitter.
Then press the P2 programming button (back) 1 x on the handheld or wall transmitter to be reprogrammed.
5. The motor (shutter) briefly moves UP/DOWN and/or the receiver beeps*.
6. OK - Handheld transmitter is added!
Delete handheld and wall transmitters
1. Power is ON (motor is connected and ready for operation).
2. Press the P2 programming key once. Motor beeps.
3. Press the STOP key once. Motor beeps.
4. Press P2 programming key 1 x. Motor beeps 3 x*.
5. OK! ALL handheld transmitters are deleted!
* The frequency of the beeps or the reaction of the motor / shutter depends on the receiver.
For further information, please refer to the instructions of the Julius Mayer hand-held and wall-mounted transmitters.
34
Press the P2 key Press the UP key
(back) on the on the handheld
handheld transmitter transmitter once.
once. The motor "beeps".
The motor "beeps".
Press the P2 key
(back) of the already
programmed hand-held
or wall transmitter 2
times.
The motor "beeps "*.
(individual deletion of handheld or wall transmitters is NOT possible!)
Press the P2 key Press the UP key
(back) on the on the handheld
handheld transmitter transmitter once.
once. The motor "beeps".
The motor "beeps".
Press key P2 (back)
of the handheld
transmitter 1 x.
The motor "beeps"
3 x*.
Press the P2 key (back)
of the new handheld or
wall transmitter to be
programmed 1 x.
The motor "beeps "*.
Press key P2 (back)
of the handheld
transmitter 1 x.
The motor "beeps"
3 x*.