Disposal Instructions - Julius Mayer JM35-F Serie Montageanleitung

ATTENTION!
The following mounting
instructions must be observed!
Before installation, compare the
mains voltage / frequency
specifications on the type plate with
those of the local mains.
The changeover time for changing
the running direction must be at
least 0.5 seconds!
The switches or controls used must
not execute a simultaneous UP/
DOWN command!
Moving parts of motors that are
operated below a height of 2.5
m above the ground must be
protected.
The winding shaft must be mounted
horizontally! If the hangings are
wound up at an angle, the motor or
the hangings may be damaged.
Inspection openings must be easily
removable and accessible and must
not be permanently closed off
inaccessibly.
IMPORTANT!
For permanently installed devices, a
disconnecting device for each phase
must be provided on the part of the
installation in accordance with DIN
VDE 0700.
Switches with a contact opening
width of at least 3 mm (e.g. circuit
breakers, fuses or RCDs) are
considered to be disconnecting
devices.
The manufacturer's liability for
defects and damage is excluded if
these are due to non-observance
of the assembly and operating
instructions (incorrect installation,
incorrect operation, etc.).
22
GENERAL SAFETY INSTRUCTIONS
ATTENTION!
The following installation instructions
must be observed!
The range of radio controls is
regulated by the legal requirements
for radio systems and is influenced by
structural conditions, among other
things.
When planning, make sure you have
adequate radio reception.
This is especially true if the radio
transmitter is located in a different
room than the radio receiver, and
therefore the radio signal must
penetrate walls or ceilings.
Do not install the radio control in
the direct vicinity of large metallic
surfaces.
Other transmitting devices (e.g. radio
headphones, baby monitors, radio
weather stations) whose transmission
frequency is identical to that of the
radio control unit may interfere with
reception.
IMPORTANT!

Disposal instructions!

European Directive 2012/19/EU (WEEE)
Our electrical and
electronic products
are marked with a
crossed-out wheeled
garbage can, indica-
ting that these pro-
ducts and any batte-
ries they may contain
must be collected
separately at the end
of their life and not be disposed of
with other household waste.