Zelmer ZJE3800 Benutzerhandbuch Seite 7

EN PL
ASSEMBLING
1. Put the middle part onto the main machine.
2. Put the juicing net onto the middle part and press it slightly so that the elements fit in together.
3. Put down the transparent cover on the middle part.
4. Lock the handle on the transparent cover.
12
5. Install the pulp container on the machine.
6. Turn on the machine and put the fruit into the inlet, then use the pushing bar to lightly press the fruit.
NOTES PRIOR TO USE
1.This machine is equipped with safety unit. When the handle does not fasten the cover or the cutter seat
is not fastened, the motor cannot run to ensure safety for the user.
2.When disassembling or assembling the juicer, press the upper part of the inlet in the cover with your hand
and then force the handle to slide in or out of cover slot.
3.When disassembling the juicing net, first remove the cover and pulp container, then put up the middle
part by holding juicing outlet with your hand and take it up. The juicing net will automatically leave the rotor.
4.In order to avoid damage, before using, first check power supply for compliance with rated voltage.
5.Clean all the parts which can disassembled (refer to "Maintenance and cleaning" section).
6.When assembling, please carefully read the diagram of "Names and positions of main components".
7.Please carefully read the "Notes" section before using the machine.
JUICING
1.Before using, please confirm the button switch of the main machine is in stop / "O" position. In this way,
if the assembly is not completed, the main machine cannot start and unnecessary damage for users or
property can be avoided.
2.Before juicing, first confirm juicing net and rotor are clutched in position and there is no hard contact be-
tween the juicing net cutter and the transparent cover. Put the transparent cover on, put the handle into the
cover slot and then turn the machine on.
3.Put prepared vegetable or fruit into the juicer inlet, press with the pushing bar, evenly, hard and slowly.
EN
PL
13