MALTEC DH-12000 Bedienungsanleitung Seite 26

.Mode
Auto mode - continuously drying mode-sleeping mode cycle, press once to switch the
mode from one to another, the corresponding indicator lights up.
● Auto mode: when environmental humidity ≥ set humidity +3%, the fan starts working
and compressor starts working after 3 seconds. When environmental humidity ≤ set
humidity -3%, the compressor stops working and fan stops working after 30 seconds'
delay.
Both fan speed and humidity can be adjusted under auto mode.
● Continuously drying mode: The machine continues to run, but the humidity can not be
adjusted.
● Sleeping mode: Touch the sleep button, the button lights up and start the sleep
function. After no operation in 10 seconds, all indicators turns dark gradually and the wind
speed is automatically switched from high to low. Touch any button to wake up the
indicator. Touch sleep button again to exit the sleep mode.
When environmental humidity ≤ 57% ，compressor stops working and the fan shut down
after 30 seconds' delay.
When environmental humidity ≥ 63% ， the fan starts working and compressor starts
working after 3 seconds.
Fan speed and humidity can not be adjusted under sleeping mode.
Timer
Press the timer button to set the 0-12 hour timing function. The interval is 1 hour. Each
time you press this button, the value increased 1 hours and then the corresponding timing
value is displayed on the screen. The setting value is "00" to cancel the timer function. The
indicator turns out. After the timer is set and completed, the timer LED is on during the
timing period. After the timing is over, the timer LED turns off automatically.
In the running state, set the time to turn off the machine;
in the standby state, set the time to turn on the machine.
Humidity set
Touch the humidity button to check the current environment humidity, touch this button
again and you can set the humidity. The range of target humidity is 30%- 35% - 40% - 45%
- 50% - 55%- 60% - 65% -70% - 75%- 80%. After setting 3 seconds, the system confirms
the input value and then the machine exits the setting state, and returns the current
humidity. In the drying mode, the target humidity cannot be changed.
Long Press humidity button for 3 seconds to display the current ambient temperature.
26/48