Mono Mode - ESX signum SX-5800 Bedienungsanleitung

X-Over- (Front-/Rearsystem 1 up to 4 Channel)
• When you use bigger speaker systems (Ø20cm plus),set on FULL RANGE-position (FULL RANGE).
• When you use smaller speaker systems (Ø8.7cm - Ø16cm), set on HIGHPASS- position (HIPASS). The cut-off frequency should be
• between 60Hz - 150Hz. It is controlled by the HIPASS-regulator. When you use this configuration the LOPASS CONFIG - Switch is out of
• function.
Subwoofer (Channel 5)
•The cut-off frequency should be between 60Hz - 100Hz. It is controlled by the Lowpass-regulator
Bass EQ-(Channel 5)
• Allows you to adjust the bass boost from 0dB up to 12dB
Caution!
Please use the Bass-Boost carefully. The additional boost may result in clipping or overload.
Level
• Turn the INPUT LEVEL control on the amplifier to 5V position.
• Turn the head unit volume control to about 80-90% of its full setting.
• Turn the INPUT LEVEL control clockwise until you hear some distortion.
• Then turn back the INPUT LEVEL control slightly until you can hear clean sound.
Mode
• If there is only one RCA output at your head unit, set mode-switch on 2CH-postion.
• 5CH-Stellung bringen.
Connection for
Remote to adjust
the subwoofer from
REMOTE
your seat
Connect RCA
Cables from head
unit with RCA
inputs (LINE INPUT
1CH/2CH &
3CH/4CH)
5- Channel Amplifier SX-5800
Speaker wiring and Connection
Interconect cable checklist :
• Connect the RCA outputs from head unit with the RCA Inputs (LINE INPUT 1CH&2CH / 3CH&4CH) of
• the 4 Channel amplifier with two RCA Cables.
• Connect the RCA outputs of the (LINE OUT) 4-Channel Amplifier with the RCA inputs(LINE INPUT) of
• the 1-Channel/Mono amplifier with an RCA cable.
• Connect the Front- & Rear-Speakers with a good RCA cable with the speaker outputs (SPEAKER
• OUTPUT/ + 1CH -, + 2CH -, + 3CH -, + 4CH -) of the 4-Channel amplifier.
• Connect the Subwoofer with a good RCA Cable with the Speaker outputs (SPEAKER / + -) of the 1-
• Channel/Mono Amplifier.
• The minimum final speaker impedance must not be below 2 Ohm per channel. Too low speaker loads
• result in too high heat dissipation and may cause the amplifier run into protection.
• Please observe speaker channel and polarity as printed by the speaker terminal
Be careful not to connect speaker (-) to the ground or vehicle chassis.
LEVEL INPUT
Caution!
Subwoofer
2 - 8 Ohm
Front-Speakers
4 - 8 Ohm