Champion CPG4000DHY-EU Bedienungsanleitung Seite 23

CPG4000DHY-EU - 3500W WIRELESS REMOTE START OPEN FRAME INVERTER

Battery power is drawn while the generator is in standby mode
(START/STOP button flashing green).
The generator will stay in standby mode for 12 hours if shut
down using the Remote Control.
To turn standby mode off manually, push and hold the "STOP"
button on the remote control for 5 seconds or push and hold
the START/STOP button on the control panel for 5 seconds.
The RCM will no longer consume any battery power or wait for
remote signal. This is indicated by the START/STOP button no
longer flashing.
Manual Stop
1. Turn off and unplug all electrical connected loads. Never start
or stop the generator with electrical devices turned on.
2. Let the generator run at no-load for several minutes to
stabilize internal temperatures of the engine and generator.
3. Press the START/STOP button.
4. Turn the fuel valve to the "OFF" position.
Important: Always ensure that the START/STOP button is "OFF"
and not illuminated and fuel valve is in the "OFF" position when
the generator will not be used for an extended period of time.

If the engine will not be used for a period of two (2) weeks or
longer, please see the Storage section for proper engine and
fuel storage.
NOTICE
NOTICE
Moving the Generator
– NEVER lift or carry the generator using the folding handle.
– ALWAYS place the generator on its wheels in the upright
position.
– ALWAYS turn the generator off and ensure the fuel valve is
closed.
– ALWAYS make sure engine and muffler are cooled down
before the generator can be handled safely (typically 15-30
minutes).
1. Begin by raising the folding handle, found on opposite side of
wheels.
2. Using the handle, tilt the end of the generator slightly off the
ground until balanced on the wheels.
3. While maintaining balance, roll the generator to the desired
location.
– NEVER tilt sideways while moving the generator.
– Failure to follow these instructions could result in personal
injury or damage to the generator.
Operation at High Altitude
The density of air at high altitudes is lower than at sea level.
Engine power is reduced as the air mass and air-fuel ratio
decrease. Engine power and generator output will be reduced
approximately 3½% for every 1000 ft. of elevation above sea level.
At high altitudes increased exhaust emissions can also result due
to the increased enrichment of the air fuel ratio. Other high altitude
issues can include hard starting, increased fuel consumption and
spark plug fouling.
To alleviate high altitude issues other than the natural power
loss, CPE can provide a high altitude carburetor main jet. The
alternative main jet and installation instructions can be obtained
by contacting our Technical Support Team. Installation instructions
are also available in the Technical Bulletin area of the CPE website.
The part number and recommended altitude range for the
application of the high altitude carburetor main jet is listed in the
following table.
In order to select the correct high altitude main jet it is necessary
to identify the carburetor model. For this purpose, a code is
stamped on the side of the carburetor. Select the correct high
altitude jet part number corresponding to the carburetor code
found on your particular carburetor.
23
OPERATION
EN