Collomix CMG 1700 Originalbetriebsanleitung Seite 14

Assembly

Disconnect the mains plug from the wall
plug before carrying out any tasks on the device.
Adjusting the handle
Open the two wing nuts left and right and move
the handle to the desired position. Tighten the
wing nuts again.
Mounting the diamond grinding disk:
Select a diamond grinding disk that matches the
grade and speci昀椀ca琀椀on of the material to be pro-
cessed.
Only use diamond grinding disks that comply with
the data listed in the table below.
Ensure the correct size, height and diameter of the
hole in the diamond cup wheel.
The permissible rotational speed of the diamond
grinding disk used must at least match with the
data listed in the following table.
Please note the data provided on the diamond
grinding disk regarding its rotational and circum-
ferential speed.
[mm] Max. rota琀椀onal
max D
[mm]
d speed [min
125 22.2
► Unscrew the coupling nut (8) from the thread-
ed spindle using the socket spanner provided.
While doing this, press the locking bu琀琀on (2)
and turn the spindle by hand un琀椀l you can feel
it engage.
► A 昀氀ange nut (6) is a琀琀ached to the threaded
spindle to stabilise the cup wheel. When work-
ing with the suitable Collomix diamond cup
wheel, always ensure that the 昀氀ange nut is in
place. Do not operate the device without the
昀氀ange nut.
► Centre the diamond cup disk (11) on the 昀氀ange
nut and spacer disk.
► Use a pinhole spanner to 琀椀ghten the clamp
nut (10) on the threaded spindle. Press and
hold the arrester bu琀琀on (3) while doing so to
prevent the spindle from turning.
► Check the cup disk for correct sea琀椀ng and free
running before switching on the machine. The
disk must not come into contact with the pro-
tec琀椀ve hood or other parts.
The cup wheel can heat up during use. Leave to
cool. You could burn your hands or cut/ tear your
skin on the segments. Always wear protec琀椀ve
work gloves when changing tool inserts.
max.
] [m/s]
-1
12250 80
Carry out a test run in a safe posi琀椀on and without
any material load. Interrupt your work immediate-
ly if you no琀椀ce the tool running irregularly.
Only use original accessory parts!
Moun琀椀ng the cup wheel
height
[mm]
22
Rev. 2 / 14
6
7
8