Mode Of Operation - Heathus Wedel Montageanleitung

STEP 4:
Screw the chimney into the bracket. With two ST5x10 (D) screws in both sides. Check the unit for stability.
Operation
Power
Make sure that the ON / OFF switch on the left side is in the OFF position. Connect the unit to a power outlet
(see IMPORTANT SAFETY INSTRUCTIONS pages 2). Make sure the outlet is in good condition and that the plug is
not loose. NEVER
exceed the maximum current rating for the circuit. Do not connect other equipment to the same circuit.

Mode of operation

This electric fireplace can be operated from the CONTROL PANEL, which is located on the right side, or with the
supplied remote control. The operation and functions of the two methods are the same. Please read the
IMPORTANT SAFETY INSTRUCTIONS on pages 2 and 3 before operation.
BUTTON ACTION / FUNCTION
ON: Activates the control panel
functions and
remote control. Turns on the flame
effect.
OFF: Disables the control panel
functions and remote control.
Turns off the flame effect.
RESULT
•
Press once. The control lamp
lights up. The unit switches on.
All functions are activated
•
Press again. The flame effect is
switched off. Power and all
functions switched off.