Operation; General Information; Electrical Connection - Heathus Lund Aufbau- Und Bedienungsanleitung

Operation

General information

Unpack the electrical fireplace carefully and keep the packaging for future use, for example in case
you need to pack up the device if you are moving, or to return it to your specialist retailer.
Do not connect the heating device to the power supply, before it has been properly installed.
Note: If the device is used in an environment with only minor background noise, you may be able to
hear the sound of the motor used to operate the flame effect. This is normal and you do not need to
be concerned.
Warning: The device is not equipped with a device for controlling the room temperature. The he-
ating device must not be used in small rooms that are occupied by individuals who are unable to
independently leave the room, unless constant supervision is ensured.

Electrical connection

WARNING: THIS DEVICE MUST BE GROUNDED
Caution: During operation, the device should not vibrate noticeably, as this may lead to failure of
the lamp. Please turn the device off before moving, servicing or cleaning it.
Manual operation
The switch is located on the back of the heating device. There are three switches to control the
heat settings.
Switch number 1 controls the power supply and flame effect.
Note: This switch must be turned to ON, to allow the device to operate with or without heat.
Switch number 2 controls heating with 600W (on / off)
Switch number 3 controls heating with 1200W, together with switch number 2
Note: The flame effect can be used with or without the heating function.
- 19 -
11035 Lund EF480_E .indd 19 14.11.18 10:05