Problems And Solutions - Sinji SMART PANEL HEATER Bedienungsanleitung

EN
CLEANING
Always disconnect the appliance and allow it to cool down completely before carrying out maintenance. Use a hoover to remove
dust on grilles. Clean the outside of the unit with a damp cloth and then dry it with a dry cloth. Never immerse the appliance in water
or allow water to drip into it.
STORAGE
Always disconnect the unit, let it cool down completely and clean it before storing it. If you are not going to use the unit for a long
time, put the unit and the instructions back in the original box and store it in a dry and ventilated place. Do not place heavy objects
on the box during storage as this may damage the appliance.

6. PROBLEMS AND SOLUTIONS

Problem: The Smart Panel Heater does not turn on.
Cause:
Device is tilted.
Solution: Install the device in an upright position. It has a sensor that switches it off if it is tilted or falls over.
Problem: The Smart Panel Heater does not connect to my network.
Cause:
Wifi netwerk is Dual Band van 5GHz.
Solution: Change the settings of your router so that your network only transmits 2.4GHz. If necessary, switch off Dual band
t emporarily or rename the 5GHz network.
Problem: The Smart Panel Heater does not connect to my network.
Cause: The Smart Panel Heater is not in pairing mode.
Solution: Reset the Smart Panel Heater by pressing and holding the power button for 5 seconds.