The Control Panel; Switching On And Off - Sinji SMART PANEL HEATER Bedienungsanleitung

2. Attach 2 brackets to the bottom of the product, as shown in the picture below.
3. Hold the side of the Smart Panel Heater, look at the position of the wall slot of the back cover, and slide the wall to the top of the
slot.
Note: Before drilling, make sure that there are no cables or other pipes on or in the wall in order to prevent damage. Remember that
the screws must be firmly and securely seated in the wall to ensure safe installation of the electric heater on the wall. Observe the
safe distance below.
During installation, ensure that the heating element is placed at a safe distance from flammable materials, gas and water.
When installed on the wall, the installation height must be more than 15 cm from the ground and at least 50 cm from the ceiling.

4.THE CONTROL PANEL

4.1 Switching on and off

The heater emits a beep when it is switched on. The heater will start in standby mode, displaying the WiFi symbol and the current
temperature of the room.
Press the ON/OFF button. You see the heating icon and the ECO mode icon. This means that the device is in ECO mode.
4.2 Changing the heating mode
To change the heating mode, press the MODE button to cycle through the modes: ECO mode, Comfort mode and Anti-freeze mode.
The mode icons will flash as you go through them. After a few seconds the icon will stop flashing and the heater will start heating in
that mode.
4.3 Setting the desired temperature
The set temperature of Eco mode and Comfort mode can be adjusted with the UP and DOWN buttons. The temperature range is
from 5°C to 50°C. In Antifreeze mode, the Smart Panel Heater will ensure that the temperature always remains above 5°C.
4.4 Timer for switching off
To set the timer, press the TIME button while the heater is in heating mode. The timer range is 1 - 24 hours. The numbers will flash
during the setting process and then the display will return to heating mode. The timer icon on the display indicates that the timer has
been set. The heater will continue to heat until the set time has elapsed.
Wi-Fi Connection
Comfort mode
Eco mode
Anti-Frost mode
Keyboard Lock
Shows timer or
temperature setting
EN
EN
Current temperature
Timer
Heating element
status on/off