Switch On The Smart Panel Heater; Make Sure Your Smartphone Is Connected To Your Wi-Fi Network; Open The Smart Life App And Tap '+' To Select The Device You Want To Add; Install The Smart Panel Heater - Sinji SMART PANEL HEATER Bedienungsanleitung

EN
5. And then press the square with the dash in it on the top right:
6. Your phone's camera will open, then scan the following qr code with your phone to add the Smart Panel Heater:
7. Follow the steps in the app to complete the installation.
8. If the Panel Heater does not flash quickly, reset it by putting it in standby mode and pressing the power button for 5 seconds.
B) Manually adding the Smart Panel Heater

1. Switch on the Smart Panel Heater.

2. Make sure your smartphone is connected to your Wi-Fi network.

3. Open the Smart Life app and tap '+' to select the device you want to add.

4. Select "small household appliances".
5. Select "heating (wifi)".
6. Follow the steps in the app to complete the installation.

3. INSTALL THE SMART PANEL HEATER

Before installation, check that all parts are complete and the product is intact.
The Smart Panel Heater can be installed free-standing or on the wall.

Freestanding installation

If you want to use the electric heater as a free-standing unit, mount it with the feet provided and follow the instructions below.
Ensure that the heater is mounted on a flat, stable and clean surface.
1. Turn the product upside down on a soft cotton cloth or carpet to avoid damage.
2. Attach the feet to the bottom of the heating element with the screws provided. Align the holes in the foot with the holes in the feet,
insert the screws through the holes and tighten them with a screwdriver.

Installation on the wall

1. Take 4 brackets, 6 plugs and 6 screws from the box, and attach 2 brackets to the wall according to the distances between the
holes of the bracket, as shown in the illustration below. Use the included measuring template to easily drill the holes in the right
position
400