GGM gastro BISTROT 465 Bedienungsanleitung Seite 14

Pag. 12
Automatic washing System operation:
Filling the washing circuit
With the electronic oven control activated, press key
-
Scroll using key " " until displayed is the programme "FILL" .
Confirm the selection using key
Check that the hoses of the machinery are empty before proceeding with the execution of
the program.
Doing so starts the operation of filling the washing circuit with products. At the end of this
operation the acoustic indicator shall emit a signal. Circuit filling must be carried out for each
operation on the tanks (product replacement or filling). For more safety when filling the
washing circuit with products, perform the procedure twice.
At this point the wash cycle is ready to be activated.
Washing programmes
There are 4 washing programmes:
LAV 1: Delicate: suitable for frequent washing procedures to remove residues that are
not particularly hard to remove after baking non fatty products. Duration: 42'
LAV 2: Normal: for traditional oven use, with residuals and encrustations resulting
from consecutive baking cycles of products that are not particularly fatty.
Duration: 1h 04'
LAV 3: Intensive: suitable after numerous daily baking cycles of particularly fatty
foods, such as pizza, focaccia, etc. Duration: 1h 34'
LAV 4: Super Intensive: suitable after an intensive and multiple use of the oven with
particularly fatty foods, such as 3 or 4 cooking processes of chickens with the oven fully
loaded. Duration: 1h 56'
To run a washing programme, press key
-
" " until the desired programme is displayed.
Confirm the selection using key
. To run the programme, press key
to enter programmes mode. Scroll with key
and run the programme using key
to enter the programme modes.
.
.