Herunterladen Inhalt Inhalt Diese Seite drucken

Cleaning, Maintenance And Storing - MIA LU 0171 Bedienungsanleitung

Ultraschall-kaltluftbefeuchter
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Before switching on manufacturer recommends to leave the unit in the room for about half
an hour to acclimatise to the room temperature.
It is recommended to use the unit under temperature of 5-40C, relative humidity about
40 - 60% RH.
Use clear water not over 40C.
Check the water basin, make sure it is clear. To minimize calcification use soft water.
To fill the water tank, remove it from the motor base and turn it upside down. Open the lid
of the water tank by turning it counter clockwise.
Fill in required litres of water over a sink (see water level scale for reference) and ensure
that the silicon gasket fits properly. Then turn the lid clockwise to lock and ensure that the
tank is now leak proof. Fill up to max litres mark only. Do not overfill to avoid overflow and
damage. The scale on the water tank indicates litres and hours. The indications are
averaged terms of reference and apply for low steam output adjustment (steam control in
position „ON"). If a stronger steam output has been adjusted, the exhaust of water particles
is much higher and the time will be minimized accordingly.
Take the water tank out of the base, open the lid of the water tank, and fill the water tank
with clear water. Close the lid, and put the water tank onto the base carefully.
Put the steam nozzle into opening on top of the water tank.
Connect the main supply, switch on the unit (NEVER RUN THE UNIT WHEN THERE IS
NO WATER IN WATER BASIN), the green control lamp inside the unit will illuminate. The
unit starts working. Cold steam will evaporate.
Adjust steam output by turning the steam control. Turning it to the right (clockwise) will
maximize, turning to the left (counter clockwise) will minimize.
The steam output can be adjusted in each direction when turning the steam nozzle
on top of the unit.
If the red control lamp inside will illuminate the water tank is empty and must be refilled.
For safety reason always switch off and unplug before removing the water tank in order to
refill. Then remove the water tank open the lid and refill. Close the lid, and put the water
tank onto the base carefully.
The appliance is equipped with a night light. The switch is below the steam control. Switch
on or off the blue night light if desired.
Always switch off and for safety reason unplug after each use.

Cleaning, maintenance and storing

Caution! Before cleaning, changing accessories or when carrying the unit always switch
OFF and unplug the appliance!
Caution Danger of electric shock! Never immerse the motor, unit body or cord into water
or any other liquids. Ensure that the unit never comes into contact with water.
In case when the water is hard which means water contains too much calcium and magnesium,
this can cause "white residues" problem and give heavy scales on the surface of water basin,
transducer and inner surface of the water tank. Scales on the surface of transducer will unable
the unit work properly.
We recommend:
1) Use cold boiled water or distilled water.
2) Clean the transducer, water tank and basin unit every week.
3) Change the water in water tank more often to keep it fresh.
4) Make sure to pull out the water from the water tank and dry the water basin before you
14

Quicklinks ausblenden:

Werbung

Kapitel

Inhaltsverzeichnis
loading

Verwandte Produkte für MIA LU 0171

Inhaltsverzeichnis