Electrolux LUT1NE32W Benutzerinformation Seite 33

Problem
The compressor does not
start immediately after
pressing the "Super
Freeze", or after changing
the temperature.
Door is misaligned or inter‐
feres with ventilation grill.
Door does not open easily. You attempted to re-open
There is too much frost
and ice.
Water flows on the floor.
Temperature cannot be
set.
Possible cause
Food products placed in
the appliance were too
warm.
The door is not closed cor‐
rectly.
The Super Freeze function
is switched on.
The compressor starts af‐
ter a period of time.
The appliance is not level‐
led.
the door immediately after
closing.
The door is not closed cor‐
rectly.
The gasket is deformed or
dirty.
Food products are not
wrapped properly.
Temperature is set incor‐
rectly.
Appliance is fully loaded
and is set to the lowest
temperature.
Temperature set in the ap‐
pliance is too low and the
ambient temperature is too
high.
The melting water outlet is
not connected to the evap‐
orative tray above the com‐
pressor.
The Super Freeze function
is switched on.
ENGLISH
Solution
Allow food products to cool
to room temperature be‐
fore storing.
Refer to the "Closing the
door" section.
Refer to the "Super Freeze
function" section.
This is normal, no error
has occurred.
Refer to the installation in‐
structions.
Wait a few seconds be‐
tween closing and re-open‐
ing of the door.
Refer to the "Closing the
door" section.
Refer to the "Closing the
door" section.
Wrap the food products
better.
Refer to the "Operation"
chapter.
Set a higher temperature.
Refer to the "Operation"
chapter.
Set a higher temperature.
Refer to the "Operation"
chapter.
Attach the melting water
outlet to the evaporative
tray.
Switch off the Super
Freeze function manually,
or wait until the function
deactivates automatically
to set the temperature. Re‐
fer to the "Super Freeze
function" section.
33