Cleaning And Maintenance - Bauknecht BAK3 KN8V IN Kurzanleitung

CLEANING AND MAINTENANCE

Make sure that the oven has cooled
down before carrying out any
maintenance or cleaning.
Do not use steam cleaners.
REMOVING AND REFITTING THE DOOR
To remove the door, open it fully and lower the catches until
they are in the unlock position (1). Close the door as much as you
can (2). Take a firm hold of the door with both hands - do not
hold it by the handle. Simply remove the door (3) by continuing
to close it while pulling it upwards (a) at the same time until it is
released from its seating (b).
~60°
1 2
Put the door to one side, resting it on a soft surface. Refit the
door by moving it towards the oven, aligning the hooks of the
hinges with their seating and securing the upper part onto its
seating. Lower the door and then open it fully. Lower the catches
into their original position: make sure that you lower them down
completely. Try closing the door and check to make sure that it
lines up with the control panel. If it does not, repeat the steps
above.
CLICK & CLEAN - CLEANING THE GLASS
After removing the door and resting it on a soft surface with the
handle downwards, simultaneously press the two retaining clips
(1) and remove the upper edge of the door by pulling it towards
you (2).
TROUBLESHOOTING
Problem
The oven does not work.
The display shows the
letter "F" followed by a
number.
Download the complete Use and Care Guide from docs.bauknecht.eu for more informations about your product
Policies, standard documentation and additional product information can be found by:
• Visiting our website
• Using QR Code
• Alternatively,
booklet). When contacting our After-sales Service, please state the codes provided on your
product's identification plate.
Do not use wire wool, abrasive
scourers or abrasive/corrosive
cleaning agents, as these could
damage the surfaces of the appliance.
a
3
Possible cause
Power cut.
Disconnection from the mains.
Software problem.
docs . bauknecht. eu
contact our After-sales Service
1
~15°
Lift and firmly hold the inner glass with both hands, remove it
b
and place it on a soft surface before cleaning it.
To correctly reposition the inner glass, make sure that the "R"
is visible in the right-hand corner and the clear surface (not
printed) is facing up.
First insert the long side of the glass indicated by "R" into the
support seats, then lower it into position.
Refit the upper edge: a click will indicate correct positioning.
Make sure the seal is secure before refitting the door.
Solution
Check for the presence of mains electrical power and whether
the oven is connected to the electricity supply.
Turn off the oven and restart it to see if the fault persists.
Contact you nearest After-sales Service Centre and state the
letter or number that follows the letter "F".
(See phone number in the warranty
Wear protective gloves.
The oven must be disconnected from
the mains before carrying out any kind
of maintenance work.
2
Model: xxxXXXXxx XXXXXXXXXXXXXX