Kidwell PINO Benutzerhandbuch Seite 14

1
Start assembling the rocker by putting the front liner on the chassis (see the figure) and
bolt down the rear stops to the rocker frame. Bolt down the washers with the bolts (B1).
NOTE: Repeat on both rocker frame assemblies.
2
With both rocker frames assembled, fasten the stabiliser bar to join them. Use the bolts
(A1) by inserting them through the stabiliser bar and into the rocker frame so that the end
of the bolt is inside of its retainer (see Parts, pos. 12).
NOTE: Both frames should have the backrest adjustment button facing outwards (see
Parts, pos. 10).
3
To assemble the rocking lock, insert the bolt (A2) through the first part of the retaining
block, from its outside. Mount the rocking lock on the protruding end of the bolt. Next,
install the second part of the retaining block to secure the system; tighten the bolts (A2)
and (B2), with the latter screwed into from the inward side (see the figure).
NOTE: Do not overtighten the bolt or the product could be damaged.
4
Bolt the module mount to the rocker frame with the bolts (A3) as shown in the figure. With
the parts assembled, you can install the module in the mount guides located underneath
(see the figure).
One end of the module mount features a locating pin to align the part with the chassis.
5
Press the backrest chassis into the holes on the backrest adjustment system. Press until
a click is heard which means the lock is engaged and the backrest chassis is properly
connected to the rocker chassis.
6
Put the textile liner over the backrest chassis and pull down for a snug fit. With the textile
liner taut, secure the buckles under the rocker and make sure the liner fits the chassis
well.
7
Attach the toy bar to the rocker by inserting the former into the dedicated holes by the
backrest adjustment system. The toys feature Velcro straps for quick installation and
14