Start-Up And Operation - Hama 00176614 Bedienungsanleitung

1. Please break through the pre-perforated opening
on the rubber grommet in the plate in order to
thread the cables through as shown in Fig. 2.
2. Attach the plate using the supplied screws and
plugs to the position you have determined on
the wall.
3. Attach the cables on the product's terminal block.
4. Fit the camera to the pre-mounted plate on the
wall. To do this, use the 2 short screws and the
close the holes with the rubber plugs supplied.
5. Switch your fuse back on.
4

7. Start-up and operation

Warning
• Please note that lights (even LEDs) can
generate heat and may become hot. Always let
the light cool down for a few minutes before
touching it.
• The device may only be operated on a 230
V 50 Hz AC voltage network. Work on the
230 V network must only be carried out by
an electrician certified in your country. The
applicable accident prevention regulations must
be adhered to.
• To avoid an electric shock from the device,
please disconnect the mains voltage (switch off
the automatic circuit breaker). Failure to comply
with the installation instructions can cause fires
or other hazards.
Risk of electric shock
Do not open the product and do not operate it if
it is damaged, if smoke, a strange smell or loud
noises are coming from it. Immediately contact
your dealer or our service department (see item
"Service and Support").
Note
Light source can be replaced
by a specialist (LED only).
Warning
Never look straight into the light source and do
not aim its beam of light straight into the eyes of
other people or animals. This could
damage your/their eyes.
Note
This light contains a light source of energy
efficiency class "F".