Safety Instructions - Hama 00176614 Bedienungsanleitung

G Operating Instructions
Controls and displays
1 Microphone
2 Motion Detector
3 Status LED
B: Reverse
4 Micro-SD card slot
5 Reset button
6 Loudspeaker
Thank you for choosing a Hama product.
Take your time and read the following instructions
and information completely. Please keep these
instructions in a safe place for future reference. If
you sell the device, please pass these operating
instructions on to the new owner.
1. Explanation of symbols used on the
product label
Electrical device of safety class
II.Protection against electric shock
thanks to reinforced or double
insulation of live parts.
The product must only be used with
alternating current.
Non-dimmable.The lamp is not
suitable for use with a conventional
dimmer.
The article may only be connected by
a qualified electrician who complies
with national regulations and those
of the local energy supply company,
and who has sufficient knowledge
regarding installation locations, fire
protection and electrical installation
work.
Attention! There is a risk of electric
shock on contact.
2
A: Front
2. Explanation of warning symbols and notes
Risk of electric shock
This symbol indicates a risk of electric shock from
touching uninsulated product parts that may carry
hazardous voltage.
Warning
This symbol is used to indicate safety instructions
or to draw your attention to specific hazards
and risks.
Note
This symbol is used to indicate additional
information or important notes.
3. Package contents
• 1 WiFi floodlight camera
• 1 mounting kit
• 1 quick reference guide

4. Safety instructions

Warning
• The camera is part of the building installation.
During planning and setup, the relevant
national standards and directives must be
observed. The device may only be operated on
a 230 V 50 Hz AC voltage network. Work on
the 230 V network must only be carried out
by an electrician certified in your country. The
applicable accident prevention regulations must
be adhered to.
• To avoid an electric shock from the device,
please disconnect the mains voltage (switch off
the automatic circuit breaker). Failure to comply
with the installation instructions can cause fires
or other hazards.
• When connecting to the device terminals, note
the permissible cables and cable cross-sections
for this.
• Observe the circuit diagram carefully!
Non-interchangeable
adapter.