A&D GX-AE Schnellstartanleitung Seite 8

EN
When pressed and released
Key
Turns the display
turned off. The weighing mode is enabled when the display is turned on.
When password function is enable, password input display will be displayed. Refer
to the separate instruction manual "19-4 How to Input The Password At The Start Of
Weighing"
This ON:OFF
operation will interrupt operation and turn the display OFF. *
In the weighing mode, turns the digit for
readability on and off.
In the counting or percent mode, enters the
sample storing mode.
Switches the weighing units stored in the
function table. Refer to "4. Weighing".
Displaying of the unit mg is available for
0.0001g models only.
Performs calibration of the balance using
the internal mass. (GX-AE / GX-A series)
Stores the weighing data in memory or
outputs to a printer or personal computer
depending on the function table settings.
(Factory setting = output)
Sets the display to zero.
* When the "Gross net tare function" is selected, the display is turned off by pressing and holding
(for 2 seconds). Please refer to the separate instruction manual "14. Gross Net Tare Function".
ON:OFF . The standby indicator is displayed when the display is
key is available anytime. Pressing the
8
When pressed and held
(for 2 seconds)
ON:OFF
- Enters the function table mode.
Please refer to the separate
instruction manual "9. Function
Table".
- Runs the repeatability check
function when pressed and held for
another 2 seconds after the function
table menu is displayed.
Please refer to the separate
instruction manual "20.
Repeatability Check Function".
(GX-AE / GX-A series only)
Displays other items of the calibration
menu. Please refer to the separate
instruction manual "6-2 Self Check
Function/Automatic Setting Of
Minimum Weighing Value by ECL".
Displays other items of the calibration
menu.
Enters mode to change the unit mass
registration number in counting mode.
By changing the function table:
- Outputs "Title block" and "End
block" for GLP, GMP report.
- Displays the data memory menu.
- Enters mode for reading density
number in flow measurement.
key during