Cleaning And Maintenance - Bimar Z6 Bedienungsanleitung


 It is advisable to hook-up the insect-killer between 1,5 and 2,5m of height, in no ventilated area and
no lighted rooms (or with not much light), so the insect-killer lamp can attract the insects.
 The power socket must be easy to reach so the plug can be removed quickly in case of emergency.
 The appliance is not to be used in locations where flammable vapour or explosive dust is likely to
exist.
 Do not use the appliance with a timer or a programmer or with a system that can switch on the
appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is covered or
positioned incorrectly.
 Make sure that the electric cord is correctly positioned, not touching hot or sharp surfaces and not
wrapped around the appliance or twisted or tangled, to prevent the appliance from falling. Make sure
that it cannot be tripped over, to avoid accidental falls or injury.
 In the event of a breakdown or poor operation, turn the appliance off and ask for professionally
qualified help.
USE
Inserting the plug into the power socket, the lamp turn on: the light attracts the insects and the electric
shock kills them when they fly inside the grid. In this way, they fall into the suitable round container at
the base device. To clean it, remove the plug from the current socket and rotate it in anti-hour
movement. To switch off remove the plug from the socket.
When not in use for long periods, the plug must always be removed from the socket.

CLEANING AND MAINTENANCE

Attention: before cleaning the appliance remove the plug from the current socket.
 To clean the appliance, use a slightly damp humid cloth; do not use metal pads or abrasive products.
 Do not wash it under running water, do nor submerge it in water.
 Never immerse the appliance in water or any other liquid.
 The insects that remain between the grids have to be removed with a small brush: do not use tools like
a screwdriver.
 When the appliance is not in use, place it in a dry environment.
 Special tools are needed to replace the electric cable and the lamp (type F4 T5 BL): contact an
authorised repair centre even for small repairs.
 Should you decide not to use the appliance any more, we recommend making it inoperative by cutting
the power cord (after making sure you have disconnected the plug from the socket) and make
dangerous parts harmless if children are allowed to play with them (for example lamp).
 Do not dispose of non-biodegradable products in the environment but dispose of them in accordance
with current law. At the end of its working life, the product must not be disposed of as urban waste. It
must be taken to a special local authority differentiated waste collection centre or to a dealer
providing this service. Disposing of a household appliance separately avoids possible negative
consequences for the environment and health deriving from inappropriate disposal and enables the
constituent materials to be recovered to obtain significant savings in energy and resources. As a
reminder of the need to dispose of household
appliances separately, the product is marked with a crossed-out wheeled dustbin. Bear in mind
that: the insect killer body is made of plastic - the grid and the hook-up ring are of steel - the
electrical wires are made of copper coated with rubber.
6/12