Makita CW002G Gebrauchsanleitung Seite 10

4. Selecting th e control temperature
P ress the temperature setting button to select
the control temperature. Refer the chapter
" S P E C IFI C ATIONS " for the selectable control
temperature.
The appliance starts cooling / heating 5 seconds after
w ithout any operation , then the control temperature stop
ashing and the temperature display sho s the current
temperature.
The appliance stops cooling / heating w hen the current
temperature reaches the control temperature.
Tips for efficient cooling / heating
• Opening the upper cover for long periods can
cause significant increase decrease o the
temperature in the chamber.
• Regularly clean surfaces that can come in contact
w ith food and accessible drainage systems.
tore ra meat and fish in suita le containers in
the chamber , so that it is not in contact w ith or drip
onto other food.
• If the chamber is left empty for long periods:
itch o the appliance
- Defrost the chamber.
- C lean and dry the chamber.
- Leave the upper cover open to prevent mould
developing w ithin the chamber.
FUN C TION
Indicating th e remaining battery
capacity
The battery indicator sho w s the remaining battery
capacity. The remaining battery capacity is sho w n as
the follo w ing table.
Battery indicator status
Lig h ted
(Blinking)
R emaining
capacity
Off
50 % to 100 %
20 % to 50 %
0 % to 20 %
C harge the
battery.
(Only for battery cartridges w ith th e
indicator)
P ress the check button on the battery cartridge to
indicate the remaining battery capacity. The indicator
lamps light up for a fe w seconds.
► Fig.3 1. Indicator lamps
Indicator lamps
Lig h ted
NOTE: Depending on the conditions of use and the
am ient temperature, the indication may di er slightly
from the actual capacity.
NOTE: he first ar le t indicator lamp ill link hen
the battery protection system w orks.
Appliance / battery protection
system
The appliance is e q uipped w ith the protection
system his system automatically cuts o po er to
e x tend appliance and battery life. The appliance w ill
automatically stop during operation if the appliance or
battery is placed under one of the follo w ing conditions.
• Battery overdisch arge protection
W hen the battery capacity becomes lo w , the
appliance stops automatically. The battery
indicator prompts that the battery should be
charged. Remove the batteries from the appliance
and charge the batteries.
• Overcurrent protection
W hen the appliance / battery is operated in a
manner that causes it to dra w an abnormally high
current , the appliance automatically stops. In this
situation , stop the application that caused the
appliance to become overloaded. Then turn the
appliance on to restart.
• Low - voltage protection
W hen the car input voltage is lo w er than the
rated oltage, this protection system turns o the
appliance and the temperature display sho w s " F3 "
w ith beep sound.
1 0 E N G L IS H
2. C heck button
Off Blinking
75 % to 100 %
malfunctioned.
R emaining
capacity
50 % to 75 %
25 % to 50 %
0 % to 25 %
C harge the
battery.
The battery
may have