VONROC HT501DC Bersetzung Der Originalbetriebsanleitung Seite 10

EN
• To switch off, release one or both switches.
Trimming a hedge - best method
• Apart from hedges the hedge trimmer may also
be used for cutting bushes.
• The best cutting effect is achieved when hol-
ding the blade at an angle to the of approx. 15°.
• The opposite rotating knives cut on both sides,
and it is therefore possible to trim the hedge in
both directions.
• The side of the hedge are trimmed using curved
shaped movements from the bottom and upwards.
• Ideally a hedge should be wider at the bottom
than the top. This will improve light penetration,
keeping the hedge healthy. If possible, trim
both sides of the hedge.
• When trimming the sides of the hedge, trim
from the bottom upwards. This will ensure there
are no hedge trimmings obscuring or interfering
with your cut strokes. The blade should not be
forced to cut too deep. Cut lightly through the
surface of the hedge.
• When trimming the top of the hedge, trim away
from you but do not over-reach. It is much wiser
and safer to move along and cut within your
reach remaining on two feet at all times.
Safety transport
The hedge trimmer has a transport protection Co-
ver (8) for save transportation of the machine.
5. MAINTENANCE
Before cleaning and maintenance, always
switch off the machine and remove the
battery pack from the machine.
Clean the machine casings regularly with a soft
cloth, preferably after each use. Make sure that the
ventilation openings are free of dust and dirt. Re-
move very persistent dirt using a soft cloth moiste-
ned with soapsuds. Do not use any solvents such
as gasoline, alcohol, ammonia, etc. Chemicals such
as these will damage the synthetic components.
Cutting blade
• Always wear gloves when handling or cleaning
the cutting blade.
• Clean the cutting blade and spray with a
protective oil after every use. We recommend
10
lubricating the cutting blade with protective oil
at regular intervals during long working periods.
• Visually inspect the condition of the cutting
blade Check that the screws are fi rmly seated in
the cutter bar.
• Ensure that the blade guard is fi tted on the
machine.
Storage
The hedge trimmer should be kept in a safe, dry
place, well out of the reach of children. Do not
place other objects on top of it.
ENVIRONMENT
Faulty and/or discarded electrical or
electronic apparatus have to be collected at
the appropriate recycling locations.
Only for EC countries
Do not dispose of power tools into domestic waste.
According to the European Guideline 2012/19/EC
for Waste Electrical and Electronic Equipment and its
implementation into national right, power tools that
are no longer usable must be collected separately
and disposed of in an environmentally friendly way.
WARRANTY
VONROC products are developed to the highest
quality standards and are guaranteed free of defects
in both materials and workmanship for the period
lawfully stipulated starting from the date of original
purchase. Should the product develop any failure
during this period due to defective material and/or
workmanship then contact VONROC directly.
The following circumstances are excluded from this
guarantee:
• Repairs and or alterations have been made
or attempted to the machine by unauthorized
service centers;
• Normal wear and tear;
• The tool has been abused, misused or
improperly maintained;
• Non-original spare parts have been used.
This constitutes the sole warranty made by compa-
ny either expressed or implied. There are no other
warranties expressed or implied which extend
beyond the face hereof, herein, including the im-
WWW.VONROC.COM