Control Panel - SuperFish Solar Fish Feeder Gebrauchsanweisung

Function
With this automatic feeder you can automatically feed your fish. Feeding a smaller quantity of food on a regular basis has
a beneficial effect on the health of the fish and pond. Feeding several times a day ensures maximum growth of your fish
and beautiful colour patterns. Because the fish eat all the food, there will be less pollution of the water and it reduces the
load on the filter.
Installation
• Place the Fish Feeder in an accessible place near your pond so that it can be easily refilled with food. Ensure that
the Fish Feeder is anchored to avoid tipping over. You can secure it in two ways.
Fig. A Attach the supplied ground pins to the underside of the Fish Feeder and firmly set it into the ground.
Fig. B Or fasten the feeder on the floor (e.g. on a deck) using 4 screws (not supplied).
Fig. C Ensure that the Fish Feeder is completely level.
Fig. D Place the insert ring in the bottom of the container when feeding small pellets (2-4 mm).
• Fill the container with pellets (max. 6 litres) of the appropriate size pellet.
NOTICE! Make sure the food remains dry at all times. If the food becomes moist, the feeder may block and not
function correctly.
Fig. E Switch on the Fish Feeder; the on/off switch is on the left hand side.
• To test the operation of the Fish Feeder, press and hold the 'RUN' button on the control panel for as long as the
beep sounds. A small amount of food will now be dispensed.

Control panel

Using the control panel on the device you can program the following settings:
• The current time/clock (CURRENT TIME).
• The spreading coverage to approximately 1, 2 or 3 metres ( DISTANCE S, M or L ).
• The number of feedings up to 6 times a day with the feeding times (SET TIMER).
• The dosing time of the different feedings between 0 and 20 seconds (RUN TIME).
• The display also indicates the battery level and whether the battery is charging.
• Use the 'SET' button to switch between the different settings and to confirm the set values.
• Use the arrows  and  to change the times and values.
• For manual feeding, press and hold the "RUN" button for the duration of the beep.
Feeding time
Current time
Feeding session
SET TIMER
1
CURRENT TIME
00;00
SET
Settings Up Down
Charging
Battery level
Dosing time
RUN TIME
DISTANCE
Spreading distance
S M L
RUN
Manual
5