Charging The Battery; Inserting The Battery; Removing The Battery - Hilti SF 8M-A22 Original Bedienungsanleitung

5 Preparations at the workplace
WARNING
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1

Charging the battery

1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery. → page 18
5.2

Inserting the battery

WARNING
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the product until it engages with an audible click.
3. Check that the battery is seated securely.
5.3

Removing the battery

1. Press the battery release buttons.
2. Remove the battery from the tool.
5.4 Installing the side handle
1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2. Slip the side handle over the chuck.
3. Adjust the side handle to the desired position.
4. Tighten the side handle.
5.5 Fitting the accessory tool
1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2. Check that the connection end of the accessory tool is clean. Clean the connection end if necessary.
3. Open the keyless chuck.
4. Insert the accessory tool into the keyless chuck and then turn the chuck firmly by hand until tight and
several clicks are heard.
5. Check that the accessory tool is held securely.
5.6 Removing the accessory tool
1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2. Open the keyless chuck.
▶ If the chuck refuses to open, use the enclosed hook wrench for more leverage.
3. Pull the accessory tool out of the keyless chuck.
20 English
2
2065390
*2065390*