Herunterladen Inhalt Inhalt Diese Seite drucken

Connecting The Cuff To The Monitor; Body Posture During Measurement; Applying The Cuff - Eks Vision Plus 0300 Bedienungsanleitung

Automatisches blutdruckmessgerät für oberarm
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 22
5

Connecting the cuff to the monitor

Insert the cuff tubing connector into the socket on the left side of the monitor. Make
sure that the connector is completely inserted to avoid air leakage during blood pressure
measurements.

Body posture during measurement

Sitting measurement
a. Sit with your feet flat on the floor.
b. Place your arm, palm upwards, on a flat surface or table.
c. The cuff should be at the same level as your heart.
Lying down measurement
d. Lie on your back.
e. Place your arm straight along your side with your palm upwards.
f. The cuff should be at the same level as your heart.
6

Applying the cuff

a. Remove tight fitting clothing from the upper arm.
b. Place the cuff around the arm 1-2cm above the
elbow joint.
c. If sitting, place your hand, palm upwards, on a flat
surface such as a table.
d. Position the air tube in the middle of your arm in
line with your middle finger. Fig. 3
Note: The red strip on the cuff should be facing
downwards towards your hand. Fig. 2
e. Pulling the cuff end through the medal loop
(the cuff is packaged like this already), turn it
outward (away from your body) and tighten it and
fasten with the Velcro strip.
f. The cuff should fit comfortably, yet snugly around
your arm. You should be able to insert one finger
between your arm and the cuff.
Note:
• Measure on the same arm each time.
• Stay quiet and calm for 5 minutes before blood pressure measurement.
• Do not move your arm, body or the monitor and do not move the rubber tube during
measurement.
• If the cuff becomes dirty, remove it from the monitor and clean it by hand with a mild
detergent and rinse it thoroughly in cold water. Never dry the cuff in a clothes dryer or
iron it.
7
Taking a blood pressure reading
a. Apply the cuff and sit or lie comfortably. Press the START
button. A beep is heard and all display characters are shown
for self-test. Fig. 4
5
Fig. 2
2cm
Fig. 3
mmHg
kPa
Fig. 4
2cm

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis