Operating Procedures - Eks Vision Plus 0300 Bedienungsanleitung

2
Some advice
1. Remain calm and preferably rest for 5 minutes before blood pressure measurement.
2. The cuff should be placed on the upper arm at the same level as your heart.
3. During measurement, do not speak or move your body and arm.
4. Measure the same arm for each measurement.
5. Relax a minimum of 3 to 5 minutes between measurements to allow the blood circulation
in your arm to recover. Prolonged over inflation of the cuff may cause a slight swelling
(ecchymoma) of your arm.
6. Remove the batteries if the monitor is not be used for a month or more to avoid damage by
battery leakage.
7. This blood pressure monitor is designed for adults and should never be used on infants or
young children. Consult your physician or other health care professionals before use on
older children.
8. Blood pressure measurements determined by this monitor are equivalent to those obtained
by a trained observer using the cuff/stethoscope auscultation method. These are within the
limits prescribed by the American National Standard, Electronic or automated
sphygmomanometers.
9. Please avoid strong magnetic interference such as that from mobile telephones, microwave
ovens, etc.
10. If an irregular heartbeat – IHB (arrhythmias) is detected while making a blood pressure
measurement, a signal of will be displayed. This may affect the function of the blood
pressure monitor and results may not be totally accurate. It's recommended that you
consult with your physician for a second opinion.
11. Make sure to store and use the monitor within the temperature and humidity ranges specified.
3

Operating procedures

BATTERY
• Insert 4 x "AA 1,5V" size batteries in the battery compartment at the back of the unit.
Make sure that the polarities are placed correctly.
• When the LCD shows the battery symbol, replace all batteries with new ones.
• Rechargeable batteries are not suitable for this monitor.
• Remove the batteries if the monitor is not to be used for a month or more to avoid
damage from battery leakage.
4
Set clock and date
• Once you install the battery or turn off the monitor, it will
enter clock mode and the LCD alternates between time
and date. Fig. 1
• While the monitor is in clock mode, press both the START
and MEM buttons simultaneously and the number for month
will flash. While the number is flashing press the MEM button
to change the number. Press the START button to move to the
number for the day. While the number is flashing press the
MEM button to change the numbers. Repeat this procedure for
the hour and minutes.
• While the minute number is blinking, press the START button
to confirm.
• Once you change the batteries, you should check and readjust
the time and date.
4
Fig. 1