Clock And Date Adjustment; Connecting The Cuff To The Monitor; Applying The Cuff - AEG BMG 5612 Bedienungsanleitung

English
86
The monitor, the batteries and the cuff, must be disposed of according to local
regulations at the end of their usage.

2. CLOCK AND DATE ADJUSTMENT

a. Once you install the battery or turn off the monitor, the unit will enter Clock Mode
and the display will display the time and the date.
b. When the unit is in Clock Mode, press the "START" button and the "MEM" button
simultaneously for 2 seconds; the month will flash first. Press the button "START"
repeatedly; the day, the hour and the minute will flash in turn. See Fig. 2 to 2-3.
While a number is flashing, press the button "MEM" to increase the number. Hold
the button "MEM" depressed, the number will increase rapidly.
Fig. 2
c. You can turn off the monitor by pressing the "START" button when the minutes are
flashing, then the time and the date are confirmed.
d. The monitor will turn off automatically after 1 minute of no operation; with the time
and date unchanged.
e. After replacing the batteries, you should set the time and the date again.

3. CONNECTING THE CUFF TO THE MONITOR

Insert the cuff tubing connector into the socket in the left side
of the monitor. Make certain that the connector is completely
inserted to avoid air leakage during blood pressure
measurements.
Avoid compression or restriction of the connection tubing during measurement, as
this may cause an inflation error or harmful injury due to continuous cuff pressure.

4. APPLYING THE CUFF

a. If required, pull the cuff end through the medal loop
(the cuff is packaged like this already).
b. Place the cuff around a bare arm 1 to 2 cm above the
elbow joint.
Fig. 2-1 Fig. 2-2 Fig. 2-3