Hama 00223551 Bedienungsanleitung Seite 3

Warning - Batteries
• Avoid storing, charging and using in
extreme temperatures and at extremely
low atmospheric pressures (such as at high
altitudes).
Note
Remove the rechargeable batteries from the
charger once charging is complete.
4. Charging rechargeable batteries of type
AA, AAA
Warning
• Only operate the product from an approved
socket that is connected to the public power
supply. The socket must be installed close to
the product and must be easily accessible.
• Disconnect the product from the power
supply using the On/Off switch – if this is
not available, unplug the power cord from
the socket.
• If using a multi-socket power strip, make
sure that the total power consumption of all
connected devices does not exceed the power
strip's maximum throughput rating.
• If you will not be using the product for a
prolonged period, disconnect it from mains
power.
Rechargea-
ble battery AAA/Micro
type
NiCd/NiMH 2/4
300 – 1200
Recc. capacity
mAh
Charging time 5.2 – 21.0 h
Charging
75-90mA
current
Charge factor
0.0175
(in h/mAh)
Calculate the charging time (for empty rechargeable
batteries):
Max. charging time (in h)
= Capacity of the rechargeable battery x charge
factor
E.g.: 2 x AA 2000 mAh rechargeable batteries:
2000 x 0.007
= 14 h max. charging time
• Insert 2 or 4 rechargeable batteries into the
• For micro/AAA rechargeable batteries, use the
• AA and AAA rechargeable batteries can be
• Plug the device into the socket.
• If the rechargeable battery is inserted correctly,
• Calculate the max. charging time according to the
• The charging times in the calculation example are
5. Care and maintenance
Note
AA/Mignon
Disconnect the device from the mains before
cleaning and during prolonged periods of
non-use.
2/4
• Only clean this product using a lint-free, slightly
500 – 2800
mAh
• Ensure that no water is able to enter the product.
3.5 – 19.6 h
6. Warranty disclaimer
150-190mA
Hama GmbH & Co KG assumes no liability and
provides no warranty for damage resulting from
improper installation/mounting, improper use of
0.007
the product or from failure to observe the operating
instructions and/or safety notes.
7. Technical data
charger, observing the correct polarity - see the
labels in the charging bay!
lower-lying charging bays.
charged simultaneously in the device.
the LED above the charging bay lights up by way
of con rmation.
table. Once the charging time has elapsed, the
rechargeable batteries must be removed in order
to avoid over-charging them.
guideline values for empty rechargeable batteries!
Rechargeable batteries with residual charge
need to be charged for a shorter period of time
accordingly.
damp cloth and do not use any harsh cleaners.
Input
220–240 V~ / 50
Hz / 6 W
3