Basic Setup - Philips NeoPix Ultra 2 Bedienungsanleitung

2 In the 4-corner correction interface, press
OK to select an image corner, then press
/ to adjust the horizontal positioning
values, and /
positioning values. Repeat the same step to
adjust positioning values of the other image
corners if desired.
3 To exit correction mode, press

Basic setup

Step 1: set up the language
1 On the home screen, press
to display the shortcut options. Then select
the icon on the upper right of the home
screen and press OK, then go to Language
Setting.
Use the Navigation buttons and OK on the
remote control to make changes.
• Language: Select your desired language for
on-screen menus.
• Input Method: Select a keyboard input
method.
• Android Keyboard Settings: Make settings
for Android keyboard.
Step 2: activate on-screen pointer
Activate the on-screen pointer (mouse cursor)
to replace the function of the Navigation
buttons on the remote control. The on-screen
pointer is useful when you input text through
pop-up virtual keyboard, browse the Internet,
or use some certain apps.
Before you can use the on-screen pointer, pair
the remote control with the projector.
1 Go to the Bluetooth settings.
On the home screen, press
to display the shortcut options. Use the
Navigation button on the remote control
to select Bluetooth to access Bluetooth
setting. Enable Bluetooth by selecting
Bluetooth ON/OFF if not enabled.
Initial operation
to adjust the vertical
or
once or more
once or more
.
2 Hold down
for five seconds. The remote control is
automatically paired with the projector.
"Philips AirMote" is displayed under the
paired devices list of the Bluetooth setting.
• When the remote control is paired with the
projector, the LED on the remote control
flashes blue briefly each you press a button
on the remote control.
To use on-screen pointer
1 When the remote control is paired with the
projector, press
display or cancel the on-screen pointer.
2 When the pointer (a circular mark) is
displayed on the projection screen,
move the remote control in the air then
the pointer moves across the screen
correspondingly.
3 Press the OK button on the remote control
to confirm selection.
and on the remote control
on the remote control to
11