Supply Voltage - Sauter EGQ222F931 Bedienungs- Und Montageanleitung

G
EGQ222F931
Connecting scheme
Power supply
AC 24V~ 0V
DC 15-36V = GND

SUPPLY VOLTAGE :

For operating voltage reverse polarity protection, a one-way rectifier or
reverse polarity protection diode is integrated in this device variant.
This internal one-way rectifier also allows operating 0 - 10 V devices on AC
supply voltage.
The output signal is to be tapped by a measuring instrument. Output
voltage is measured her against zero potential (O V) of the input voltage!
When this device is operated on DC supply voltage , the operating voltage
input UB+ is to be used for 15...36 V DC supply and UB – or GND for
ground wire!
Temperature table
MR: 0 ...+50 °C
°C U
A
in V
0
0.0
5 1.0
10 2.0
15 3.0
20
4.0
25 5.0
30 6.0
35 7.0
40
8.0
45 9.0
50 10.0
Individual operation
Circuitry
V
9
Connecting scheme
Power supply
AC 24V~ 0V
DC 15-36V = GND
When several devices are supplied by one 24 V AC voltage supply, it is to
be ensured that all "positive" operating voltage input terminals (+) of the
field devices are connected with each other and all "negative" operating
voltage input terminals (–) (= reference potential) are connected together
(in-phase connection of field devices). All outputs of field devices must be
referenced to the same potential!
In case of reversed polarity at one field device, a supply voltage short-
circuit would be caused by that device. The consequential short-circuit
current flowing through this field device may cause damage to it.
Therefore, pay attention to correct wiring!
Parallel operation
Circuitry Circuitry