Kidwell BENO Benutzerhandbuch Seite 19

3.2). Make sure that the ends of the frame tubes come out of the bottom of the seat
holes at the same height.
3. Assemble the front, lower part of the frame with non-slip pads. To do this, place the
ends of the lower frame into the tubes of the upper frames while pressing the locking
buttons (fig. 3.3).
NOTE: Make sure that the locking buttons of the lower frame have slipped into the
locking holes and are extending beyond the outline of the frame.
4. Install the rear, lower part of the frame with the wheels in the base similarly to the
front part. You should also make sure that the locking buttons have slipped into the
dedicated locking holes and are extending beyond the frame outline (fig. 3.4).
5. Slide the table with the locking buttons pressed in at the same time, onto the armrests
of the high chair, which are the guides for the table. The buttons that lock the table in
the guides are located underneath on both sides of the table (fig. 3.5).
WAYS OF ADJUSTING AND FOLDING THE HIGH CHAIR
2
1. Seat height adjustment
• Press both locking buttons at the same time (fig. 1.11) and adjust the height of
the seat using the 6 available locking settings (fig. 4.1).
2. Backrest inclination adjustment:
• Tilt down both locking hooks at the same time (fig. 1.8) and adjust the angle of
the backrest inclination to one of the 3 available levels (fig. 4.2).
3. Tray table adjustment:
• Press both locking buttons on the underside of the table at the same time
(fig. 1.9) and set the distance between the table and the child to one of the 2
available levels (fig. 4.3).
NOTE: Pay attention to ensure comfort and freedom to your child, do not move the
table too close.
4. Safety harness adjustment:
• Use the sliders to adjust the length of the straps and make sure your child sits
safely and comfortably in the high chair. Then fasten the harness to prevent
your child from falling out of the high chair. To unfasten the harness, press the
button on the buckle (fig. 4.4).
5. Footrest reclining adjustment:
• Press both lock release buttons at the same time (fig. 1.13) and adjust the
footrest to one of the 2 available positions (fig. 4.5).
6. Folding the high chair:
• First, remove the table. To do this, press both locking buttons on the underside
of the table at the same time (fig. 1.9) and slide the table out of the guides.
• Then lower the seat to the lowest level in accordance with point 2.1. "adjustment
methods" and set the footrest to a horizontal position.
• Slide both seat folding locking levers upwards (fig. 1.12) at the same time and
fold the seat (Fig. 4.6).
• Press both upper frame locking buttons (fig. 1.10) at the same time and fold the
frame (fig. 4.7).
• The last step is to fix the disassembled table with the tray to the fixing hooks
(fig. 4.8).
19