3.8.2
In stal la ti on ver si on 2
In ju ry ha zard from im pro per lif ting and trans port.
Crush ing haz ard from fall ing or tilt ing of the ma chine.
w
For lift ing, only the cen tral point sus pen sion in -
stalled as stan dard is to be used.
w
Use only suit able lift ing equip ment with ad e quate
load ca pac ity.
w
Ne ver walk un der sus pen ded lo ads.
In ju ry ha zard from im pro per in stal la ti on work.
w
Per form in stal la tion work only with the en gine off, on
level ground, and with the ut most cau tion.
w
Use per sonal safety equip ment.
w
Use only per fect tools.
w
Ne ver use da ma ged parts.
w
Check whet her all parts are
– com ple te,
– un da ma ged,
– and cle an.
•
Use a cra ne to lift the ma chi ne a bit (about 15–20 cm | 6–8 in).
•
Po si ti on the pro tec ti on pla te cen tral ly un der the ma chi ne.
•
Lo wer the ma chi ne and pla ce it on the pro tec ti on pla te.
•
Use the grips (1) to pull the pro tec ti on pla te's straps (2) over
the cor ners of the base pla te (3).
•
The ma chi ne is now rea dy to use.
63
3. Ope ra ti on