Care Instructions - Teka Tegranite+ Montagehinweise

Mounting
Apply a 2­3 mm thick layer of silicone sealing
compound onto the ground edge of the sink.
Place the sink into the prepared hole in the
worktop and adjust it so that in its final
tion all fixing claws evenly engage the wood.
Press the sink into position and remove any
excess sealing compound.
screws by hand crosswise in the order shown
on the sketch below. lf you are using an elec­
tric or pneumatic screwdriver,
6.0 Nm torque.
use
Do not electric or pneumatic screwdri-
unless
vers they are equipped with
limiter.
Cross­torque fixing elements.

Care instructions

Congratulations on your purchase of this high­
quality Teka
will give you many years of pleasure. Please
make sure to follow these recommendations
for the care of your
posi­
For the daily cleaning of your Teka sink use
only normal washing up
Tighten the fixing rinse briefly with hot water and wipe dry.
Fruit juices, coffee and tea can stain the surfa­
ce of your sink if not removed. Please rinse or
do not exceed
wipe your sink promptly after contact with
these substances.
Stubborn marks or stains caused by abrasion
a from metal objects such as cutlery or pots or
torque
by staining foodstuffs can be removed with
scouring liquid or powder. Always use a mat
for hot pots.
Because Tegranit contains a high proportion of
qartz, its surface is very hard and
To remove traces of damage caused by drop­
ped objects, (but dont drop any heavy objects
on the sink!) we recommend sanding the
damaged area first with
sandpaper,
the area with scouring powder applied dry and
rinse with clear
Hard water can lead to the formation of cal­
cium deposits. lntensely coloured foodstuffs
can stain these
appear spotty. Calcium deposits should there­
fore be removed with household vinegar dilu­
ted with warm water.
sink. With a minimum of
sink.
liquid. After
scratchproof.
coarse, then with fine
using circular motions. Then,
water.
deposits, so that the sink will
care, it
cleaning,
finish
7