Teka Tegranite+ Montagehinweise Seite 6

Installation
This sink has been subjected to several qua­
lity inspections and has left our plant in per­
fect condition. Should you nevertheless find it
to be faulty, please report the defect prior to
installing the sink in order to avoid unneces­
sary costs. In this case,
in its original packaging for instection purpo­
ses. Unfortunately, we cannot admit claims her
defects discovered after mounting.
contact your specialist
complaints.
As we cannot accept liability for faulty
ting, we ask you to comply with the following
instructions.
lmportant:
Never set the sink on its edge, as this could
result in chipping!
6
1. Hole for tap fittings
The pre­drilled hole (semi­punched hole) has
the sink must remain been cut to fit taps with a shaft diameter of
35 mm.
Ensure that the sink is evenly supported wit­
Please
retailer for any hin approximately 15 mm on either side of the
pre­drilled
the hole with a small chisel or
moun­
For taps with a shaft diameter exceeding 35
mm, the hole must be
This can be done with a compass saw fitted
with a blade suitable for sawing metal.
Saw out of the hole in a
toothed pattern as shown
in the illustration and care­
fully break off the projec­
tions
pliers. Caution: do not use
force.
2.
Insert the enclosed
clamps (1) into the
preformed slots (2)
on the undersite of
the sink.
Prior to mounting
hole. From above,
widened.
thus formed with
Fixing clamps
carefully pierce
screwdriver.