Environmentally Safe Battery Disposal - WARRIOR WEP8181CS Bedienungsanleitung

ENVIRONMENTALLy SAfE bATTERy DISPOSAL

ENVIRONMENTALLy SAfE
bATTERy DISPOSAL
WARNING
The following toxic and corrosive materials are in
the batteries used in this blower.
Battery pack: Lithium-lon, a toxic material.
WARNING
All toxic materials must be disposed of in a
specified manner to prevent contamination of the
environment. Before disposing of damaged or worn
out Lithium-Ion battery packs, contact your local
waste disposal agency, or the local Environmental
Protection Agency for information and specific
instructions. Take the batteries to a local recycling
and/or disposal center, certified for lithium-ion
disposal
WARNING
If the battery pack cracks or breaks, with or without
leaks, do not recharge it and do not use. Dis pose of
it and replace with a new battery pack.
DO NOT ATTEMPT TO REPAIR IT!
To avoid injury and risk of fire, explosion, or electric
shock, and to avoid damage to the environment:
·Cover the battery's terminals with heavy-duty
adhesive tape
·DO NOT attempt to remove or destroy any of the
battery pack components.
·DO NOT attempt to open the battery pack.
·If a leak develops, the released electrolytes are
corrosive and toxic. DO NOT get the solution in the
eyes or on skin, and do not swallow it.
·DO NOT place these batteries in your regular
household trash.
·DO NOT incinerate.
·DO NOT place them where they will become part of
any waste landfill or municipal solid waste stream.
Take them to a certified recycling or disposal center.
16
TROUbLESHOOTING
PROBLEM POSSIBLE CAUSE
Battery is not secure.
Motor fails to start when switch
trigger is depressed. Battery is not charged.
Check that emergency brake is not
in working position
1.Check whether the tubing is
blocked.
No lube for guide and chain
2. Check whether there are
impurities in the oil tank blocking
the inlet pipe
Motor controller fault, or over
LED indicator of tool flashes for
temperature, or low battery, or over
1-19 times, motor fails to start
load, etc.
Slow cutting speed The chain is not sharp
The chain is too long Unadjusted tensioning components
TROUbLESHOOTING
SOLUTION
To secure the battery pack, make sure
the latches on the top of the battery
pack snap into place.
Charge the battery pack according
to the instructions included with your
model.
Push the emergency brake into working
position
1.Remove wood chips from the tubing.
2. Remove debris from the tank
1. Release the trigger and restart
the machine after 3-5s; or
2. Stop the operation and cool the
tool and battery; or charge the
battery
3. Clean wood chips and debris
from air inlet and outlet regularly
Replace the chain
Adjust the tensioning components to fit
the chain length
17
EN