Tabletop Setup / Wall Installation; Low Battery Indicator - Weinberger 40715 Bedienungsanleitung

TABLETOP SETUP / WALL INSTALLATION

Main unit
• Set up on the main device on its feet on an even surface. Fold out the foot (B9) on the bottom of
the product.
• You can hang the device on a wall using the 2 suspension eyes (B1).
Outdoor sensor
• You can also use the suspension eye (D2) to mount the product to a wall.
Suitable installation site (External sensor):
• Outdoors at a location shielded from moisture.
Wall installation:
• Required for wall installation (not included):
Tools
• Drilling machine with drill bit (suitable for size of dowel)
• Water level
• Pencil
• Ruler or tape measure
• Line locator
• Mark the drill holes at the desired installation location. Make sure there is no wiring at these
points.
• Drill the holes in the wall. Insert the wall anchors and screw in the screws. The screw heads and
approx. 5 mm of the thread should extend from the wall.
Caution: Never drill into water pipes or power lines. Use a line locator if necessary.
•
• Hang the device from the provided suspension eyes (B1/D2) .

LOW BATTERY INDICATOR

• The battery symbol (A16/A22) appears on the display of both the transmitter and weather station
when the batteries have been depleted.
• The icon reminds you to replace the batteries within the next few days.
40715-Mebus-IM-INT-V04.indb 76
Fasteners
For the main unit:
•
•
For the outdoor sensor:
•
•
76
2 Screws
2 Wall anchors
1 Screw
1 Wall anchor:
1/3/2018 3:31 PM