SCOPREGA GE20-2 Anleitung Seite 13

4. If the LED on the pressure gauge turns YELLOW, press the OFF button and connect the inflator to a car
cigarette lighter socket or an external battery via cable and power clamps.
5. If the LED on the pressure gauge turns RED, press the OFF button and connect the inflator to an
external battery via cable and power clamps.
WARNING
Make sure polarity is correct (red terminal to positive).
Otherwise the inflator WILL NOT START.
WARNING
Be careful when connecting the cable to the battery, in order not to short the battery with
conducting materials such as rings, bracelets and keys. The battery or adapter may overheat
and cause injury.
WARNING
Check the voltage. Do not connect the 12V inflator to a 24V battery.
WARNING
Do not leave the inflator running unattended. Overinflating an object could result in serious
injury.
THE INFLATOR CAN BE DAMAGED BY SAND, DUST OR WATER GETTING INSIDE THE INLET PORT. THIS
WILL CAUSE OVERHEATING AND DAMAGE THE INTERNAL COMPONENTS. SHOULD THIS BE THE CASE,
11. TROUBLESHOOTING
PROBLEM
The ON button has not been pressed.
The inflator does
not start
The inflator does
not inflate
11.1 ACCESSORY WARNING
The recommended accessories when using the inflator are the original SCOPREGA ones.
The use of any accessory not recommended for this inflator can be dangerous.
IMMEDIATELY SWITCH THE INFLATOR OFF.
POSSIBLE CAUSE
Battery LOW
The safety fuse is blown or
disconnected.
The device is damaged
Hose wrong connection.
Wrong pressure setting
Battery LOW
with RED LED ON
POSSIBLE SOLUTION
Recharge the battery using the 110-240V
battery charger or connect the device to
an external battery via power clamps
Press the ON button.
Insert or replace the fuse with one of
the same type (30 A)
Contact a SCOPREGA service
centre.
Connect the air hose to the
correct port (N3 on p.3).
Correct pressure setting.
Connect the device to an external battery
via cable and power clamps or recharge
the device.
13