Configuration - Carrier WTC-ISP Installationsanweisungen

Configuration

End of Line (EOL) termination
When there are a few devices, such as
sensors, light, blind modules, installed
together with a WTC, only the last device
EOL termination is set to ON. All other
devices must have their EOL terminations
set to OFF.
Figure 4: EOL termination ON
Device addressing
The address is set by default to position "0".
Do not modify the Subnet ID.
The Subnet ID address must remain "0"
as WTC-ISP/-ISPL is the only sensor
connectable to WTC.
Figure 6: Rotary switch – Subnet ID default position
4
The EOL termination is defined with the
EOL jumper.
EOL jumper
+
-
Figure 5: EOL termination OFF
EOL termination
ON
OFF