Cleaning And Maintenance - Siguro Sgr-Sk-R540W Bedienungsanleitung

The silicone cleansing brush is made of food-grade silicone. The brush gently
3.
cleanses and soothes the skin. It is suitable for normal to dry skin.
We recommend changing the brushes every three months.
Use
1. Place the desired brush on the head. Make sure the appliance is fully charged.
2. Wet your face.
3. Put some cleansing gel/cream in the palm of one hand and add a little water.
4. Hold the appliance in the other hand and dip the brush into the gel/cream,
making a small circular motion in the palm of your hand to create foam. Put
in on your face.
5. Press the on/off button to switch the appliance on. The brush starts to rotate.
Move the brush in a circular motion across the face from the inside outwards. Do
not apply pressure to the brush to avoid overstressing and damaging the skin.
6. Press the rotation direction setting button and select the left or right
rotation direction.
7. Use the +/- buttons to set the desired rotation speed. Use the + button to
increase the speed, the - button to decrease the speed. The speed can be

CLEANING AND MAINTENANCE

Always switch off the appliance and wait until the brush has come to a complete
stop before cleaning or carrying out any maintenance.
Warning:
Never immerse the appliance in water or any other liquid. Do not use plastic or metal
scrapers, harsh cleaners, chemicals, petrol, solvents or other similar substances to
clean any parts of the appliance. The surface finish could be heavily damaged.
selected in six stages. The appliance is equipped with a memory function.
When you switch it back on, the rotation speed you last used will start.
8. Recommended cleaning times for each part of the face:
T-zone (forehead and nose): 15 seconds
Cheeks: 15 seconds each side (30 seconds total)
Chin: 15 seconds
Neck: 20 seconds
(See Figure A on page 3.)
The appliance is equipped with an automatic intermittent timer that
corresponds to the recommended cleaning times listed above. After the
time interval has elapsed, the appliance stops running for 0.5 seconds so that
you can move the appliance. The appliance will therefore be in operation:
15 seconds (T-zone cleaning) - pause - 30 seconds (cheek cleaning) - pause -
15 seconds (chin cleaning) - pause - 20 seconds (chin cleaning).
9. When cleaning is complete, press the on/off button and the appliance will
switch off.
10. Wait until the brush has come to a complete stop and clean it and the appliance
according to the instructions in the "Cleaning and Maintenance" section.
1. The appliance is waterproof. You can therefore rinse it under running water.
Then wipe it dry with a clean cloth. You can also wipe the outer surface with
a soft cloth slightly dampened with warm water.
2. The used brush must be cleaned after each use. Rinse it in clean, warm water,
remove any dirt and wipe dry. The water must not exceed 40 °C, otherwise
the brush may be damaged. Do not dry the brush on the heater, in direct
sunlight, etc.
3. Make sure the brush is completely dry before reassembling.
EN - 7
EN