Change Of Operating Mode; Time And Timer Setting (Clock, Timer On, Timer Off); Time Setting; Timer Setting - AZURO BP-50HS-A Installations- Und Bedienungsanleitung

5.4

CHANGE OF OPERATING MODE

The heat pump has 3 operating modes - heating, cooling and automatic mode.
If you want to change the operating mode, briefly press the
the corresponding signal changes on the display, and if the compressor is running, it stops. The
compressor will start again after the safety time delay has elapsed (if the conditions for operation in the
newly selected mode are met).
5.5
TIME AND TIMER SETTING CLOCK, TIMER ON, TIMER OFF
5.5.1

TIME SETTING

Press and hold the
briefly and the hour will flash. Use the
again and use
To check the set time, press and hold the
5.5. 2

TIMER SETTING

Note: Before setting the timer, you must first set the time.
Note: 2 work cycles can be set, which will be repeated regularly every day.
You set the on and off time setting of the duty cycle in the same way as when setting the time.
To make the setting, briefly press the
displayed, which can be changed using the
press the button. Then set the ON time and the OFF time one after the other, finally confirm with
the button.
To activate and deactivate the timer, press and hold the
screen, for each of the two cycles separately.
Note: If you set the same time ON and OFF, the timer will not be used.
for about 3 seconds, the time on the display will start flashing. Press
and to set the minutes. Press the
button. A screen with a flashing cycle number is
button. The operating mode changes,
and buttons to set the hour. Briefly press the
button to confirm the setting.
button. Press the
and buttons. To select the cycle number, briefly
button in the duty cycle number selection
to end the check.
11