Affixing The Bracket And Antenna - Falcon Rural 4G Internet Solution Benutzerhandbuch

6

AFFIXING THE BRACKET AND ANTENNA

Now that all the holes are drilled the bracket is ready to be affixed to the
wall. Before doing so firstly thread the SMA cable through the pole by
removing the grommets from the bracket and threading one onto the
cable
Once threaded, pull the cable through the pole leaving enough at the top
end of the pole to connect the antenna via the screw on SMA connector.
Once the remaining cable is fed through the pole add the second
grommet to the rear of the bracket. Now connect the antenna using the
screw type SMA connector and feed any excess cable back down the
pole.
Then use the two U-bolts to fix the antenna mounting bracket to the
pole using the outer holes on the antenna mounting bracket and a
10mm spanner. Ensure that the washers are used and bolts are not over-
tightened.
Once the bolts are fitted and the antenna is secured, feed the cable
through the pre-drilled hole in the wall and affix the antenna to the wall
using a 10mm Spanner.