How To Enable Read/Write As User; How To Set The Timeout Lock In User Mode - Kingston Technology IronKey Keypad 200 Anleitung

7. How to Enable Read/Write as User

To set the KP200 to Read/Write in User mode, proceed with the following steps.
Instructions
1. Unlock the KP200 with your User PIN
2. Press the KEY button three times- (triple-click)
3. Press button number 7 followed by the
number 9 button - (79)
4. Press the KEY button once
Note:
Once activated, drive access is restored to the default Read/Write state. Admin can override User
settings by enabling/disabling Read/Write in Admin mode.

8. How to Set the Timeout Lock in User Mode

To protect against unauthorized access in the event, the KP200 is connected to a host and left unattended,
the KP200 can be set to automatically lock after a pre-set duration of time.
In its default state, the KP200 Timeout Lock feature is turned off. The Timeout Lock feature can be set to
activate (lock) an idle drive anywhere between 1 and 99 minutes.
LED LED State
Green
User PIN entry
Solid
Green
is awaiting new user defined settings
Green
Green
LED before switching to a
indicating successful Read/Write configuration
www.kingston.com
LED will be solid indicating successful
Green LED switches to blinking
and Blue LEDs indicating the drive
and Blue LEDs will continue to blink
and Blue LEDs will change to a solid
Green
Red
LED
#9