WMF Edition Kult X Gebrauchsanweisung Seite 6

Start-up
discharge button
Turbo button
speed control (1-5)
The hand-held blender is used for mixing, kneading and beating soft and liquid food and for kneading
dough that is not too solid.
The hand-held blender is delivered with two matching pairs of mixing tools.
Whisk: for low viscosity liquid food / dough (e.g. drinks, sauces, pancake batter, frothy whipped des-
serts, whipped cream etc.)
Dough hook: for more solid food / dough (e.g. bread dough, cake batters, mashed potatoes, butter etc.)
The hand-held blender is equipped with a speed controller with 5 stages.
Speed stage Mixing tool
0 (off) -
1-2 Dough hook Butter, mashed potatoes
2-3 Whisk Sauces, drinks
3-4 Dough hook Cake batter, bread dough
3-4 Whisk Frothy desserts, low viscosity dough
4-5 Whisk Whipped cream, egg white
Please clean all parts described in the "Cleaning and care" section before allowing them to come into
contact with food.
10
dough hook whisk
Examples of use
-
Make sure that the device is turned off and disconnected from the power supply.
Insert the mixing tools into both openings on the bottom side of the device. The two whisks supplied
fit into both openings. For the kneading hooks, please note that the kneading hook with a ring on the
shaft should only be inserted into the wide opening. The kneading hook without a ring may only be
inserted in the narrow opening. Turn the mixer accessories slightly until you hear them lock into place.
Only use matching pairs of mixing tools. Never use a dough hook and whisk together so as not to
damage the device.
Fill a sturdy container with the desired food. Ensure that it is sufficiently large and tall enough.
Connect the mains plug to a socket.
Keep the mixing tools in the food and set the desired mixing speed on the speed controller.
In order to reduce the food from splashing, first mix at a low speed level and then slowly increase the
speed as needed.
Caution: Do not hold the mixing tools too deep in the food. No liquid or other substances (e.g.
dough) may get into the device. If you are preparing hot food, then be sure not to hold the device in
the steam so as to avoid condensation on the device. Immediately wipe off the condensation on the
casing.
As soon as your food has the desired consistency, switch the device off on the speed controller (posi-
tion 0). Wait until the motor has stopped and remove the mixing tools from the container. Always
remove the mains plug from the socket before you place the device on a suitable base.
Clean the device as soon as possible after use. Do not allow any food to dry on the device or mixing
tools.
Turbo button
Should you require a higher speed level for a short period of time while processing food, you can also
press the turbo button. The turbo button can only be activated for speed levels 1-5, in position 0, the
turbo button is inactive. The device works at maximum speed for as long as this button is pressed.
11